BrizLabs LED String
The brizlabs_led_string light platform controls BrizLabs LED strings that have only two wires. These strings have
no data wire. The controller sends color data as short dips in the 24 V supply, and a decoder in each LED reads them.
The string is divided into zones, and each zone is one pixel of an addressable light. The zones repeat along the string: with six zones, the first group of LEDs is zone 1, the next group is zone 2, and so on up to zone 6, then the pattern starts again at zone 1. All LEDs in a zone show the same color.
This platform requires an ESP32. It has only been tested on the ESP32-C2 controller that is supplied with the string.
NOTE
The data signal is generated with the spi2 hardware SPI interface, so only one brizlabs_led_string can be
configured, and spi2 can’t be used for anything else. An SPI bus or an SPI
Ethernet adapter in the same configuration must be set to a different interface. On
ESP32 variants that have a single hardware SPI interface, such as the ESP32-C2 and ESP32-C3, an SPI bus must use
the software interface, and SPI Ethernet can’t be used.
light: - platform: brizlabs_led_string name: "LED String" pin: GPIOXXConfiguration Variables
Section titled “Configuration Variables”-
pin (Required, Pin): The pin that sends the data signal to the output stage of the controller.
-
num_zones (Optional, int): The number of zones in the string, from
1to15. Defaults to6. -
All other options from Light, except
power_estimation, which is not supported because each pixel represents a zone rather than a single LED.
Stock Controller
Section titled “Stock Controller”On the controller supplied with the string, the data signal is on GPIO0. GPIO3 enables the 24 V output stage and
must be high for the LEDs to light. Use a Power Supply on GPIO3 and set it as the
power_supply of the light, so that the output stage is on only while the light is on.
Effects
Section titled “Effects”Each zone is one pixel, so the addressable light effects can be used. With six zones, an effect has six pixels to work with.